Stainless Steel Wire Mesh for High Quality Screen Printing

Supermesh-Type HS&SHS
By using stainless steel wires of 3 times higher strength than BS with low elongation, wires are woven at an open ratio of 60%. It is appropriate for solder bump or paste dropping (WHAT IS THIS?) printing.
Cross Section View
SEM Image
Specification
SPEC MESH
COUNT
WIRE DIA.
(mm)
OPENING
RATE
THICKNESS(μm) STRENGTH
INDEX
Normal Calender
SOFT MIDDLE HEAVY
 
SHS-380/14
380 0.014 62% 32 ± 2 26 ± 2 20 ± 1 14 ± 1 0.96
 
SHS-360/16
360 0.016 60% 36 ± 3 32 ± 2 21 ± 1 16 ± 1 1.19
 
SHS-325/16
325 0.016 63% 35 ± 3 32 ± 2 20 ± 1 18 ± 1 1.08
 
SHS-290/20
290 0.020 60% 45 ± 3 36 ± 2 30 ± 1 20 ± 1 1.50
 
SHS-230/25
230 0.025 60% 55 ± 3 45 ± 2 35 ± 1 27 ± 1 1.86
 
HS-360/16
360 0.016 60% 36 ± 3 32 ± 2 20 ± 1 16 ± 1 1.05
 
HS-325/16
325 0.016 63% 35 ± 2 32 ± 2 20 ± 1 17 ± 1 0.95
 
HS-290/20
290 0.020 60% 45 ± 2 36 ± 2 30 ± 1 20 ± 1 1.32
 
HS-250/20
250 0.020 65% 44 ± 2 37 ± 2 30 ± 1 18 ± 1 1.14
 
HS-230/25
230 0.025 60% 55 ± 2 40 ± 2 30 ± 2 27 ± 1 1.64
※ "Strength Index" is the reference value setting BS325/28 to standard 1.0.
※ In order to practice high quality screen printing, we recommend "A Standard(★)" and "HS-D mesh(★★).
Back to Top